Friday, September 14, 2007

How to Handle a Tire Blowout While Riding a Motorcycle

How to Handle a Tire Blowout While Riding a Motorcycle

Introduction

Motorcycle tires rarely blow with a bang. Follow these useful steps in the event of a tire blowout and you will decrease the risk of damage to your bike while minimizing the risk of danger to yourself and others.

Steps

1.Step One
Front tire air loss is particularly dangerous because it will make your motorcycle difficult to steer. Shift your weight as far back as possible when the front tire loses air pressure.

2. Step Two
Expect the back of the motorcycle to lurch from side to side if the rear tire starts to go flat. Stay seated as you are.

3. Step Three
Hold the hand grips tightly and concentrate on steering. Maintain as straight a course as possible.

4. Step Four
Gradually apply the brake on the tire that is not flat (provided you're sure which one that is). Wait until the motorcycle slows way down, then edge toward the side of the road and stop.

Tips & Warnings

  • Inspect your tires before your ride. Check your tire pressure and make sure it conforms with the recommended psi.
  • Look for nails, staples or screws in the tires and avoid riding on the shoulder or near meridians, where sharp objects tend to end up.
  • Respond quickly to maintain your balance if a tire starts to go flat. Detect the sudden air loss from the way the motorcycle rides.
  • Carry a cellular phone whenever you ride, in case of emergencies - they fit nicely in a saddle bag or inside your jacket pocket.

How to keep your motorcycle helmet from fogging up

How to keep your motorcycle helmet from fogging up


Introduction

If you have a helmet with a face shield you have probably had to deal with it fogging up. This is just a fact of life for motorcyclists. Luckily there are some tricks that you can do to keep fogging to a minimum and possibly eliminate it all together.

Things You'll Need

Steps

1. Step One
Make sure that you are getting plenty of air flow. There are little air intakes on most helmets so if you are getting some fogging action on your helmet, increase the air flow. This alone might be enough to curb the fogging.

2. Step Two
Dish Soap
If increasing air flow isn't enough then you can put a couple drops of dish soap on your visor. Smear the soap over the inside of the visor. Make sure that you cover all of the visor.

3. Step Three
Buff the visor with a soft tissue.

 

need more??use this search engine